User Tools

Site Tools


navmesheditor

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
navmesheditor [2017/06/14 12:05] – fxfirenavmesheditor [2017/06/14 12:05] (current) – fxfire
Line 27: Line 27:
 Cube-Floor-Connections are by default automatically placed when Cubes are recorded. The MeshManager allows you to manually place additional connections, so your bot can goto smaller unconnected areas like on the left down side of this screenshot. Without these connections, the bot cannot travell from the Floor to the Cubes or the other way around. You need to make sure that the Floor-End of the connection is actually on the navigation mesh and that the Cube-end of the connection is inside a cube. Cube-Floor-Connections are by default automatically placed when Cubes are recorded. The MeshManager allows you to manually place additional connections, so your bot can goto smaller unconnected areas like on the left down side of this screenshot. Without these connections, the bot cannot travell from the Floor to the Cubes or the other way around. You need to make sure that the Floor-End of the connection is actually on the navigation mesh and that the Cube-end of the connection is inside a cube.
 \\ \\
 +
  
 === 4. Macro Mesh === === 4. Macro Mesh ===
navmesheditor.1497441918.txt.gz · Last modified: 2017/06/14 12:05 by fxfire

Page Tools