User Tools

Site Tools



sallydnc

About

This addon requires SallyLib! Make sure you have that installed from the Minion store.

SallyDNC is an Endgame PvE ACR Profile for Dancer. The combat routine is mainly intended for level 80 end game raiding. With the right gear, positioning, and awareness, you can achieve high performance. Addon comes with built in standard opener, skill bar, and hot bar that takes into account oGCD optimal weaving.

Support: https://discord.gg/U8VWV9k

Features:

  • Standard drift calculation based on skill speed
  • Tech drift calculation based on skill speed
  • Saber dance usage for flourish drift management
  • Full proc priority system management
  • High speed accurate weaving
  • Much more!

Orange Parse Notes: The ACR can definitely achieve orange parses. However, Dancer is a highly party reliant class. Thus, orange parses depends on the following things in these order:

  1. BiS Gears.This gear relies heavily on optimized gears to achieve highest results
  2. Strong party comp to give raid buffs too (looking anywhere from a 1.5k rdps vs 2.2k rdps added for good team)
  3. Kill time: Simply put, if you didn't kill at burst window, your dps will be down the drain by a few hundred
  4. Luck: parses need luck with high crit to achieve best results. This can require farming/parsing some savages

Set-up Guide


  • Step 1: Select ACR from the FFXIVMinion Menu
  • Step 2: Select ACR
  • Step 3: Select SallyDNC profile
  • Step 4: Have fun!

General Settings


From Top to bottom:

  1. Show Skill Bar: Shows the skill bar for quick selecting the Skills option
  2. Show Hot Bar: Shows the hotbar
  3. oGCD Delay: Normally a skill takes roughly ~700-750ms delay to cast. Increase this value if you are clipping. If you want to try to fit in more GCD or be more optimal, decrease this value to the bare minimum where you are not clipping.
  4. Movement Detection: Amount of time needed to detect movement for skills like reprise
  5. debug: prints messages for helping developer fix issues

AOE Settings:

  1. Use Fan 2 instead of fan one if there's x number of enemies around you
  2. Use saber at 50 esprit if there's x number of enemies around you
  3. Use Windmill combo if there's x number of enemies around you
  4. Use Bladeshower combo if there's x number of enemies around you
  5. Ignore single target proc (Cascade and fountainfall) if there's x number of enemies
  6. Ignore standard step if there's x number of enemies around you (Will still use standard for keeping up buffs)

Skills Settings


From Top to bottom:

  1. Opener: Turn on when you are ready to perform opener. Press opener at 15 Second for count down. It will automatically use standard step and then pot at 2 second. If the boss got early pulled or you started the opener late. It will automtically pot and use standard when you're in combat.
  2. Potion: Uses potion at optimal buff timing
  3. Save CD: Saves cd like devilment, standard, tech, and flourish for later
  4. Use AOE: Enables the uses of saber, fan3, windmill, and bladeshower. If this is disable, the skills won't be used
  5. Use Tech Step: enables tech step
  6. Use Standard Step: enables standard step
  7. Use Flourish: enables flourish
  8. Use Devilment: enables devilment
  9. Use SaberDance: enables saber
  10. Burns CD: Use all your fans and esprit on the boss

The skill bar corresponds to the same settings above.

QT Settings


This menu is pretty simple. It will let you change if you show skill settings in the skill bar. Also you can adjust the position and index of the skill bar with this.

QT Customize


This page customizes the number of columns, spacing, color, etc for the skill bar.

Hotbar Settings


This menu is pretty simple. It will let you change if you show skill settings in the hotbar. Also you can adjust the position and index of the hotbar with this.

Hotbar Customize


This page customizes the number of columns, spacing, color, etc for the hotbar.

sallydnc.txt · Last modified: 2020/12/13 03:39 by xsalice