User Tools

Site Tools



sallynin

About

This addon requires SallyLib! Make sure you have that installed from the Minion store.

SallyNIN is an Endgame PvE ACR Profile for Ninja. The combat routine is mainly intended for level 80 end game raiding. With the right gear, positioning, and awareness, you can achieve high performance. Addon comes with built in openers, skill bar, and hot bar that takes into account oGCD optimal weaving.

Support: https://discord.gg/U8VWV9k

Features:

  • Optimal rotation logic and rotation recovery mechanics
  • Extensive hotbar support for all jutsus
  • Customizable Huton Refresh timers and toggles
  • Smart AOE logic that saves Mudras for Suiton when AOE ends
  • 2 different movement lock mechanisms for TCJ to prevent whiffing
  • Smart True North usage based on your position and current huton timer
  • Lots of edge case logic for trick attack window
  • Extensive system for buffering skills at a super fast rate
  • Very robust system for mudra to ensure bunnies doesn't occur
  • much more :)

Orange Parse Notes: The ACR can definitely achieve orange parses. Thus, orange parses depends on the following things in these order:

  1. BiS Gears.This gear relies heavily on optimized gears to achieve highest results
  2. Melee uptime. Always be attacking. Lost of up-time will affect you tremendously
  3. Kill time: Simply put, if you didn't kill at burst window, your dps will be down the drain by a few hundred
  4. Luck: parses need luck with high crit to achieve best results. This can require farming/parsing some savages

Set-up Guide


  • Step 1: Select ACR from the FFXIVMinion Menu
  • Step 2: Select ACR
  • Step 3: Select SallyNIN profile
  • Step 4: Have fun!

General Settings


From Top to bottom:

  1. Show Skill Bar: Shows the skill bar for quick selecting the Skills option
  2. Show Hot Bar: Shows the hotbar
  3. oGCD Delay: Normally a skill takes roughly ~700-750ms delay to cast. Increase this value if you are clipping. If you want to try to fit in more GCD or be more optimal, decrease this value to the bare minimum where you are not clipping.
  4. Movement Detection: Amount of time needed to detect movement for skills
  5. Use assist's Start Combat Check: if enables, it will check for assist's combat check option to see if you are allowed to start combat
  6. Opener Mode: provides two openers (With and without pre-pull Doton)
  7. Use Throwing Dagger at >= X Yalms: Set range to use throwing dagger at
  8. Force Armor Crush Refresh at ⇐ (Seconds): When Huton reaches this timer, ACR will try to refresh ASAP
  9. Armor Crush refresh, Omni mode at ⇐ (Seconds): Timer to refresh huton at when Omni Positional toggle is used
  10. Movement check for TCJ: Enable to prevent TCJ usage during movement
  11. Debug: prints messages for helping developer fix issues

AOE Settings:

  1. Death Blossom: min target needed to use skill
  2. Hakke: min target needed to use skill
  3. HellFrog: min target needed to use skill
  4. Doton: min target needed to use skill
  5. Goka: min target needed to use skill
  6. Save a Mudra for Suiton if: max targets to use feature

Skills Settings


From Top to bottom:

  1. Opener: Turn on when you are ready to perform opener. Just attack boss after :)
  2. Potion: Uses potion at optimal buff timing
  3. Save CD: Saves CDs like Kassatsu and TA for later
  4. Use AOE: Enables the uses of Death Blossom, Hakke, Katon/Doton, and Goka
  5. TCJ Mode: Mode for TCJ order, F=Fuma, R=Raiton, S=Suiton, K = Katon, D = Doton
  6. Omni Positional: Used to identify enemies that have round hitboxes and don't require positionals
  7. Lock Movement during TCJ: Hard lock (Cannot move at all during TCJ), Soft Lock (Cannot move during TCJ setup but can cancel later), None (No movement lock)
  8. Force Armor Crush Refresh: Enables forced refresh based on the timer set in General tab

The skill bar corresponds to the same settings above.

QT Settings


This menu is pretty simple. It will let you change if you show skill settings in the skill bar. Also you can adjust the position and index of the skill bar with this.

QT Customize


This page customizes the number of columns, spacing, color, etc for the skill bar.

Hotbar Settings


This menu is pretty simple. It will let you change if you show skill settings in the hotbar. Also you can adjust the position and index of the hotbar with this.

Hotbar Customize


This page customizes the number of columns, spacing, color, etc for the hotbar.

sallynin.txt · Last modified: 2020/12/13 03:44 by xsalice