User Tools

Site Tools



sallywar

This is an old revision of the document!


About

This addon requires SallyLib! Make sure you have that installed from the Minion store.

SallyWAR is an Endgame PvE ACR Profile for Warrior. The combat routine is mainly intended for level 80 end game raiding. With the right gear, positioning, and awareness, you can achieve high performance. Addon comes with built in openers, skill bar, and hot bar that takes into account oGCD optimal weaving.

Support: https://discord.gg/U8VWV9k

Features:

  • Correct weaving of inner release to ensure 5 fell cleaves/decimate.
  • Takes into skill speed for inner release
  • Optimal AOE calculation for overpower, mythril, decimate, and cyclone
  • Optimal onslaught fillers for upheaval drifting
  • Storm eye optimal uptime
  • much more :)

Orange Parse Notes: The ACR can definitely achieve orange parses. Thus, orange parses depends on the following things in these order:

  1. BiS Gears.This gear relies heavily on optimized gears to achieve highest results
  2. GCD of 2.38 or below for optimal weaving
  3. Melee uptime. Always be attacking. Lost of up-time will affect you tremendously
  4. Kill time: Simply put, if you didn't kill at burst window, your dps will be down the drain by a few hundred
  5. Luck: parses need luck with high crit to achieve best results. This can require farming/parsing some savages

Set-up Guide


  • Step 1: Select ACR from the FFXIVMinion Menu
  • Step 2: Select ACR
  • Step 3: Select SallyWAR profile
  • Step 4: Have fun!

General Settings


From Top to bottom:

  1. Show Skill Bar: Shows the skill bar for quick selecting the Skills option
  2. Show Hot Bar: Shows the hotbar
  3. oGCD Delay: Normally a skill takes roughly ~700-750ms delay to cast. Increase this value if you are clipping. If you want to try to fit in more GCD or be more optimal, decrease this value to the bare minimum where you are not clipping.
  4. Movement Detection: Amount of time needed to detect movement for skills like reprise
  5. Use assist's Start Combat Check: if enables, it will check for assist's combat check option to see if you are allowed to start combat
  6. Opener Mode: provides four openers (ICIRIC with tomahawk start, ICIRIC melee start, ICICIR with tomahawk start, ICICIR melee)
  7. Use Tomhawk at >= X Yalms: Set range to use tomahawk at
  8. debug: prints messages for helping developer fix issues

AOE Settings:

  1. Overpower: min target needed to use skill
  2. Mythril: min target needed to use skill
  3. Decimate: min target needed to use skill
  4. Chaotic Cyclone: min target needed to use skill

Skills Settings


From Top to bottom:

  1. Opener: Turn on when you are ready to perform opener. Press opener at 15 Second for count down. It will automatically use standard step and then pot at 2 second. If the boss got early pulled or you started the opener late. It will automtically pot and use standard when you're in combat.
  2. Potion: Uses potion at optimal buff timing
  3. Save CD: Saves cd like devilment, standard, tech, and flourish for later
  4. Use AOE: Enables the uses of saber, fan3, windmill, and bladeshower. If this is disable, the skills won't be used
  5. Use Tech Step: enables tech step
  6. Use Standard Step: enables standard step
  7. Use Flourish: enables flourish
  8. Use Devilment: enables devilment
  9. Use SaberDance: enables saber
  10. Burns CD: Use all your fans and esprit on the boss

The skill bar corresponds to the same settings above.

QT Settings


This menu is pretty simple. It will let you change if you show skill settings in the skill bar. Also you can adjust the position and index of the skill bar with this.

QT Customize


This page customizes the number of columns, spacing, color, etc for the skill bar.

Hotbar Settings


This menu is pretty simple. It will let you change if you show skill settings in the hotbar. Also you can adjust the position and index of the hotbar with this.

Hotbar Customize


This page customizes the number of columns, spacing, color, etc for the hotbar.

sallywar.1578251412.txt.gz · Last modified: 2020/01/05 19:10 by xsalice